Walk-Through Metal Detectors
CS 5000

With enhanced microprocessor-based technology, the CS 5000 provides improved detection performance and increased operating flexibility. It offers many of the same features found on our advanced walk-through units and can be used in virtually any security checkpoint application. The CS 5000 is an affordable unit for the budget-conscious.

Overhead Control Unit

LCD Display, alarm lights, LED bar graphs and control touchpads plus all wiring, connections and electronics are integrated into a single lockable overhead compartment which eliminates exposure of wires and external control box.

Microprocessor Controlled

State of the art microprocessors ensure maximum sensitivity and flexible programming.

Detection Field

Unique coil design offers multidimensional detection field with total uniformity both horizontally and vertically. This design, plus a choice of three levels of ankle level boost, eliminates traditional hot spots and weak signals. Target detection is precise regardless of its location in the archway.

Audible and Visual Alarms

Audible alarm and red LED Alarm Lights indicate metal has been detected. The Red LED alarms light appears even when the audible alarm has been turned OFF. Green READY LIGHT indicates the unit has full power and is ready for operation.

The Access Control panel will be used only by supervisory management personnel. It permits changing the Program and Sensitivity codes and also is used to control such functions as synchronization of multiple units, pulse frequency and tone. The unit further secures control settings by maintaining a non re-settable sequence code that indicates any attempt at seeking access to the settings. A tamper alarm sounds within 10 seconds after the Access touchpad is pressed unless the proper access code is entered.

Specifications:

Operating Temperatures
-4?F (-20?C) to + 158?F (70?C); Humidity to 95% non-condensing
Power
Fully automatic 100 to 240 VAC, 50 or 60 Hertz, 5 watts; no rewiring, switching or adjustments required. Power supply meets UL, CSA, TUV and VDE standards.
Weatherproofing / Foreign Object Protection Standards
Meets IP 31, IEC Standard. "Degrees of Protection provided by Enclosures," CEI 529.
Tamper-Proof
Dual-level access codes required to set or change all sensitivity settings and detection programs; one level for use by supervisors in selecting programs and sensitivity and the other for initial set-up and overall control; non re-settable sequence code logs all attempts to access the settings. Audible alarm reports any unauthorized attempt at access
Construction
Attractive scratch and mar-resistant laminate with resilient end caps; control panel and cross members of heavy duty aluminum.
Control Outputs
Solid state switches (low voltage AC or DC) for operating external alarms and control devices.
Traffic Counter
Built-in and re-settable with current reading easily available on LCD panel
Synchronization
Multiple channels permit several CS 5000s and other Garrett detectors to operate simultaneously in close proximity
Interference Suppression
100% sensor coil Faraday shielding; special Garrett built-in circuitry for noise suppression and ignoring x-ray monitors. Physical interference minimized by coil design and circuitry
Alarms
Green Ready light indicates unit is operational; Red alarm lights and audible alarm is activated when the target amount of metal is detected.
Infrared Sensor
Improves analysis of detection signal; increases throughput; helps eliminate "false alarms" also provides accurate traffic counter.
Masking
Programs designed to eliminate the problem of dissimilar targets canceling each other
Warranty
Limited 24 months, parts and labor

Dimensions

	Passageway	Exterior	Shipping
Width	30" (0.76 m)	35" (0.9 m)	33.5" (0.851 m)
Height	80" (2 m)	87" (2.2 m)	91.5" (2.324 m)
Depth	23" (0.58 m)	23" (0.58 m)	6.25" (0.159 m)

E-Mail ::

Walk-Through Metal Detectors CS 5000

Walk-Through Metal Detectors
CS 5000